I currently started using my G2 and need advise on the auto ground balance. As important as it is, I'm not sure if I'm getting an accurate setting. Now, here comes out the manual from Teknetics which says to switch to all metal, set gain at 12 oclock, find a clear patch of ground and use the auto ground button while pumping the coil until ground phase numbers are within 1 or 2. Ok technical I'm not but first of all about impossible to find a clear patch of ground here with all this iron. The numbers seem to jump all over the place. If I lower sensitivity even further while ground balancing to eliminate iron etc, will this affect settings after returning to disc? I usually run sensitivity around 70, but seem to still get alot of chatter and falsing. Thought I'd put this out there as it's frustrating to say the least. Thanks for any help.
Linkback: You are not allowed to view links.
Please Register or Login
http://www.thunting.com/smf/index.php/topic,64980.msg317281.html#msg317281
|
|
Logged
|
|
